Searching dry, soft sand for a lost ring
For detectorists. How to search the soft dry sand at the top of a beach for one lost ring, why it sinks there and how to dig it out cleanly.
A lot of the rings people lose on holiday never go near the water. They come off when someone rubs in sun cream, or get slipped off and tucked into a towel, a shoe or the fold of a sunbed cushion. Then the towel gets shaken out at four in the afternoon and the ring drops into the dry sand without anyone seeing it. Dry sand sounds like the easy search, and in some ways it is. It also hides a small ring better than people expect, and it moves more than you would think.
This post is for detectorists who take on searches for one specific lost ring and want to work the soft upper beach properly.
Why a ring disappears so fast in dry sand
Loose, dry sand behaves almost like a liquid under a small heavy object. A gold band dropped on the surface will often sit there for a few minutes, and then the first person who walks past pushes it down. After a busy afternoon on a beach in Mallorca or Ibiza, with hundreds of feet going between the sunbeds and the bar, a ring can be a hand’s depth down by the evening. Children digging and sunbeds being dragged into the shade push it further.
The other thing that moves it is the beach cleaner. Many resort beaches are raked or sieved by a tractor early in the morning, and that can lift a ring, drag it along a row or bury it deeper in a ridge of sand. Before you start, ask the owner or the hotel whether the beach was cleaned since the loss, and roughly where the machine runs. It also helps to ask the sunbed attendants, because they sometimes hand in what the rake turns up.
The good news is that a ring in dry sand rarely goes far sideways. Unless the beach has been cleaned or a storm has come over the top of it, it is usually close to where it fell. So the questions you ask matter more than usual. Which row of sunbeds were they on, and which bed. Where did they shake the towel. Did they go to the bar or the showers. Ask the owner to send a photo of the exact bed if they have one, because rows look the same once they have been moved.
Setting up and searching
Dry sand is kind to a detector. It carries almost no salt or mineral signal, so the ground balance that gave you trouble at the waterline is much simpler up here, and most machines run quietly and go deeper in it. That means you can usually use a lower discrimination setting than you might want to. Be careful with that. A thin gold wedding band can sound very like a ring pull or a scrap of foil, and the upper beach is full of both. If you notch out the junk, you notch out the ring too. Dig the low, clean signals, especially anything near the sunbeds where the owner lay.
Mark out a grid with something you can see from a distance, a towel at each corner or a few sticks. Start at the place the owner remembers and work outwards in tight lanes, overlapping each sweep. Keep the coil close to the surface. In soft sand it is easy to let the coil float higher as you walk, and that costs you depth on a small target. If the area is between sunbeds, move them out of the way rather than sweeping round them, and put them back where they were.
On the busy beaches the time of day matters a lot. Early morning, before the first towels go down, is usually the best window, and you can often get an hour or two of clear sand. A calm evening after the beds have been stacked works too. On the Caribbean beaches we cover, such as Palm Beach in Aruba or Mambo Beach on Curaçao, the upper beach can get very hot by late morning and the sunbed rows fill quickly, so an early start is worth it for both reasons.
Expect a lot of rubbish. Bottle tops, coins, hair grips, bits of sunbed frame and the occasional earring all live in the dry sand near a bar. Coins are a mixed blessing. They slow you down, but they also show you where things have been dropping and settling, which is often where the ring is too.
Digging cleanly in loose sand
Dry sand falls back into the hole as fast as you dig it, which makes a spade almost useless on a small target. A long-handled sand scoop with holes in it does the job better. Take a scoop of sand from under the signal, shake it and let the sand run through. If the target is not in the scoop, check the hole with the detector or a pinpointer before you take another, because the ring may have slid down the side of the hole as it collapsed.
Keep the holes small and fill them in as you go. People will walk here barefoot in an hour, and a beach full of open holes does not make anyone want a detectorist back. It also means you are not tripping into your own holes when you sweep the grid again.
If you find nothing on the first pass, sweep the same grid again at right angles. A ring standing on its edge, or lying at the very limit of your depth, can give a faint signal from one direction and a clear one from the other. Then widen the area towards the path to the showers and the bar, because a ring that came off on the walk back is easy to forget.
Keep the owner informed while you work, even with a short message and a photo of the grid. They often cannot be there, and seeing which part of the beach you have covered helps them remember details they forgot to mention.
Ring Seekers helps people who have lost a ring on the beaches we cover. They send us the details through our get help form, and an experienced local detectorist does the search. If you already search sand beaches with a detector and would like to help people get back rings they thought they had lost, we would be glad to hear from you through our page for detectorists.