Do metal detectors work underwater, and how deep?
Yes, metal detectors work underwater if they are built for salt water. How deep the water can be, and how far into the seabed they can find a ring.
Yes, metal detectors work underwater, but only the ones made for it. A sealed, waterproof machine built for salt water can be used in the shallows or taken down by a diver, and it will find a ring a hand’s width or more into the sand under the sea.
The question “how deep” has two answers, and people often mix them up. One is how deep the water can be. The other is how far into the seabed the detector can reach. Both matter if your ring has just gone into the sea, so here is each in turn.
How deep the water can be
Every proper water detector has a depth rating from the maker. Some are only sealed for a few metres. That is plenty for a detectorist wading in the shallows or a snorkeller ducking down from the surface, but the machine should not go deeper. Others are built for diving and sealed to depths a scuba diver will actually work at. The headphones have to match, and on a cheaper set they are usually the first thing to fail.
The machine is rarely what limits a search, though. The person holding it is.
A detectorist on foot can work to about waist depth, and to chest depth on a flat calm day. Past that the coil lifts off the bottom with every wave and the scoop cannot be used properly, so the search stops being thorough. Most rings lost on holiday are lost in water the owner could stand in, which is why the wading search covers most of our sea cases.
Beyond standing depth you need someone in the water with a mask. A strong snorkeller can search a few metres down in clear water by diving repeatedly, though each dive is short and it is tiring work. A diver on scuba can stay on the bottom and cover the area properly, which is the better option once the water is deeper than a person can comfortably hold their breath for. Underwater the detector is often paired with a small handheld pinpointer, because digging a ring out of sand while floating is much harder than it sounds.
Visibility counts for as much as depth. In the clear water around east Crete, off Hersonissos and Malia, a diver can see the bottom, lay out a search line and work it carefully. In murky water with a lot of suspended sand the same diver is working by touch, and the area they can cover in a session shrinks.
How deep into the seabed it can find a ring
This is the part people are usually asking about. A ring lost in the sea does not sit on top of the sand for long. The water moves the surface around it and within minutes it starts to settle in. On a sandy bottom it is normally in the top 15 to 25 cm, and a good salt water detector reaches that comfortably.
Several things push that number up or down.
The ring itself is the first. A heavy gold wedding band gives a stronger signal than a thin stacking ring, and it is easier to pick up at depth. A thin platinum band or a small Oura ring gives less to work with, so the detectorist has to keep the coil closer to the bottom and go slower. Watches and phones are larger and usually show up well, even when they have sunk further.
The coil is the second. A larger coil reads deeper and covers more ground per sweep. A smaller coil is better at picking out one small target among bottle caps and fishing weights, which matters on a busy swimming beach. Experienced detectorists often start wide and switch down once they have the right patch.
The third is the sand. Clean pale sand is the easy case. Black volcanic sand and sand with a lot of iron in it confuse many machines and cut how deep they can read. Pebbles are worse for a different reason: the ring falls into the gaps, and the scoop cannot lift stones the way it lifts sand.
Time is the fourth, and it is the one you control. A ring lost this morning is usually close to the surface and close to where it fell. After a few days of wave action, or one rough night, it can be buried much deeper or moved along the shore. That is why we always say to get in touch as soon as you can, before the beach has had a chance to rearrange itself.
What this means for your search
If your ring went in where you could stand, a detectorist wading with a salt water machine and a scoop is usually the right search. On sheltered beaches with very little tide, like many of the coves on Ibiza and Formentera, the ring tends to stay where it dropped, and a search can be planned for a calm morning when the water is flat and the beach is still quiet.
If it went in off a boat or a pier, or while you were swimming out of your depth, it is a job for a diver. Around Malta and Gozo much of the coast is rock rather than sand, so a ring dropped from a swimming ladder or a rock ledge often lands in deeper water. A diver with a detector can work that, but only if the starting point is tight, so think about which side of the boat you were on and how far from the ladder. A boat at anchor swings on its chain, so “somewhere near where we were moored” can mean a large area.
We will be honest with you about the limits. A ring in a few metres of clear water over sand is a fair prospect. A ring in deep water over rock or thick weed is much harder, and in some places the odds are low enough that we will tell you so before anyone gets wet. If you want a feel for how the bottom, the depth and the time since the loss add up, our lost ring recovery calculator walks through it.
Before you leave the beach, line yourself up with two fixed things on shore, such as a lifeguard tower and a building behind it. Note roughly how deep the water was where you were, and the time, so the detectorist can work out where the tide was. Take a photo from the spot if you can, and keep it on your phone. Then stay out of that patch. Feet moving about in the sand push a ring deeper and spread it further, which works against everything above.
Then send us the beach, the time and how deep the water was through our get help form or on WhatsApp, along with what the ring is made of and when you fly home. The landmarks and the photo come later, in private, once you decide to go ahead. We will tell you whether it is a search on foot or one for a diver, and whether we have someone who can reach that beach. We explain the costs before any search is booked. Ring Seekers arranges searches in the water as well as on the sand, with experienced metal detectorists and, where it is needed, a diver.